How Can You Replace a Cutlass Bearing?
A cutlass bearing is a bearing on a vessel’s drive shaft log that is commonly made using brass and a lining that is grooved from the inside which is lubricated by the water which enters the grooves during rotation, this.
After some time you must change the cutlass bearing regardless of how often you use your boat. As soon as you realize it is time to make the cutlass bearing change you may find it hidden in the woodwork of the boat or some distance away from the keel.
Apart from getting your hands dirty, you will not face any challenges when removing the cutlass bearing. These are the steps to follow to replace your boat’s cutlass bearing, now.
Locating and removing the set screws should be the first thing to do. The area where you will find the layer of crud and marine is where the set screws are hidden in most cases. Not all boat manufacturers use the set screws. If you know that set screws are not existing, then it is no use wasting time looking for them.
Cutting the bearing is a must in the replacement of the cutlass bearing. If you don’t have a Sawzall with you, then a hacksaw should help you to cut the cutlass bearing. You must have enough knowledge of how to use the Sawzall tool from Propeller Depot.
Bending the cutlass bearing is the next step. With a cold chisel and a hammer, you can bend the cutlass bearing to the inside until you reach the place where you have made a cut. Avoid using a lot of force when hitting the cutlass bearing so that it can bend. If you force it you will damage the strut of the boat.
Put a maple dowel where you have created a space by bending the boat’s cutlass bearing inside and with a hammer slit it opens up to the other end. To open the cutlass bearing, avoid using any metal tools. The interior of the strut may get damaged by so doing.
Finally, remove the cutlass bearing. To remove the cutlass bearing use a pair of pliers to hold. Now clean the surface of the strut and install a new cutlass bearing. After you remove the old cutlass bearing, cleaning the surface of the strut, and want to install a new cutlass bearing bought from Propeller Depot, make sure enter the acme props in a straight line.
If the ramrod strut is forced and not straight it, you may damage it. To ensure it goes in straight, apply some grease so that the cutlass bearing washer’s can easily slide in the strut.
Reference: try this web-site